Overview of MOT changes from May 2018

Overview
The way that the MOT test works in England, Scotland and Wales changed on 20 May 2018.

The changes affect cars, vans, motorcycles and other light passenger vehicles.

Watch a video of Neil Barlow, Head of MOT Policy at the Driver and Vehicle Standards Agency (DVSA), briefly explaining what’s changed, or read the video transcript1.

PlayRewindForward
Mute- Volume Down+ Volume Up100%
The timeline slider below uses WAI ARIA. Please use the documentation for your screen reader to find out more.

00:00:00
1. Defect categories
You will categorise defects you find during the MOT as either:

dangerous
major
minor
You must record all dangerous, major and minor defects. DVSA can take disciplinary action against you if you don’t.

The MOT inspection manual tells you which defect category to use, depending on the type of problem and how serious it is.

You can still give ‘advisories’.

Item result What it means about the item How it affects the MOT result
Dangerous A direct and immediate risk to road safety or has a serious impact on the environment.

Do not drive the vehicle until it’s been repaired. Fail
Major It may affect the vehicle’s safety, put other road users at risk or have an impact on the environment.

Repair it immediately. Fail
Minor No significant effect on the safety of the vehicle or impact on the environment.

Repair as soon as possible. Pass
Advisory It could become more serious in the future.

Monitor and repair it if necessary. Pass
Pass It meets the minimum legal standard.

Make sure it continues to meet the standard. Pass
Find out more about the new defect categories and how you record them on the MOT testing service.

2. MOT inspection manual
The MOT inspection manual changed on 20 May 2018.

There are more sections and the order of the sections has changed.

The inspection manual has all the details of:

new, changed or removed failures
new, changed or removed checks
improved or changed information
Find out more about the MOT inspection manual changes and the new failures, checks and information.

3. MOT certificates and MOT history

 

 

 

Image showing samples of the old and new MOT certificate design
The old MOT test certificate (left) changed to a new style (right) to list the new types of defects.
The design of the MOT certificate has changed.

It lists any defects under the new categories, so they’re clear and easy for drivers to understand.

You can view samples of the:

MOT test pass certificate (VT20)
refusal of an MOT test certificate (VT30)
Contingency testing certificates
The ‘contingency testing’ certificates have also been updated.

You’ll have to download the updated certificates from the MOT testing service. This is because they’re automatically filled in with your MOT centre details.

You can then save a copy on your PC or tablet and print them as you need them, or print one set and photocopy them.

You must not use the old-style contingency testing certificates after 20 May 2018.

Replacement certificates
Now that the new-style certificates have been introduced, any replacement certificates you issue will be printed in this style. This includes replacements for tests that were carried out before 20 May 2018.

Welsh versions of the certificates
Previously, MOT centres in Wales printed an MOT certificate with both English and Welsh on it (bilingual).

With the new certificates, you have the option of printing in either English-only or Welsh-only.

Contingency testing certificates are only available in English.

Check the MOT history of a vehicle
The service to check the MOT history of a vehicle has been updated to reflect the new defect categories, and to mirror the certificates.

Screenshot of how the MOT history service looks since 20 May 2018
4. Diesel vehicle emissions
There are now stricter limits for emissions from diesel cars with a diesel particulate filter (DPF).

You must test vehicles to the manufacturer’s plate value (when present), or a new lower default limit for newer vehicles.

You must also give a major fault if you:

can see smoke of any colour coming from the exhaust
find evidence that the DPF has been tampered with
Find out more about the new diesel emission limits and how to find the value on the manufacturer’s plate.

5. Vehicle classifications
Vehicle categories now align to the European type-approval categories, and these appear on the MOT certificate.

The old classes will also be used for the time being.

All cars are now ‘M1’ and all goods vehicles in scope of the MOT test are now ‘N1’ – that is up to 3,500kg design gross weight (DGW).

This table sets out some the main types of vehicles.

Vehicle type Vehicle class European type-approval categories
Three-wheeled vehicles not exceeding 450kg unladen weight (ULW) (excluding motorcycle combinations) Class 3 L2 or L5
Three-wheeled vehicles more than 450kg ULW Class 4 L5
Quadricycles Class 4 L6 or L7
Cars and taxis Class 4 M1
Minibuses, motor caravans, dual-purpose vehicles and ambulances up to 12 passenger seats Class 4 M1 or M2
American pickups up to 6,500kg DGW Class 4 –
Goods vehicles not exceeding 3,000kg DGW Class 4 N1
Private passenger vehicles, ambulances and motor caravans with 13 or more passenger seats Class 5 M2 or M3
Goods vehicles between 3,001kg and 3,500kg DGW inclusive

Note: if a goods vehicle is presented with a manufacturer’s plate and a ‘ministry plate’, use the weights on the ‘ministry plate’ Class 7 N1
You can still only test goods vehicles over 3,000kg and up to 3,500kg DGW if you and your MOT centre are authorised to test class 7.

The full details for all vehicle types, including motorcycles and 3-wheelers, are in the introduction of the MOT inspection manual.

Dual-purpose vehicles
The definition of dual-purpose vehicles (see page 12 of the MOT testing guide) stays the same. The unladen weight must not exceed 2,040kg.

However, 4×4 pickup vehicles with a DGW over 3,000kg up to and including 3,500kg are considered dual-purpose vehicles for test purposes if information about the unladen weight isn’t available.

Large class 4 vehicles
A ‘large class 4 vehicle’ is a class 4 vehicle (M1 or N1) with a DGW greater than 2,500kg.

You’ll need to carry out extra checks set out in the various sections of the inspection manual.

American pick-ups
Check the MOT inspection manual for the definition of an American pick-up manufactured in the USA or Canada.

If the DGW is between 3,000kg and 6,500kg, test it as class 4 passenger vehicle (M1).

Only test vehicles that can be safely tested on the authorised equipment. You must not test them if they’re too large.

Any pickup vehicles with a 5th wheel shouldn’t be considered an articulated vehicle. Test them as normal.

6. Historic vehicles
Cars, vans, motorcycles and other light passenger vehicles don’t need to have an MOT if they’re over 40 years old and have not been substantially changed in the previous 30 years.

Previously, only vehicles first built before 1960 were exempt from needing an MOT.

Since the rules changed on 20 May 2018, vehicles meeting the criteria no longer need an MOT from the 40th anniversary of when they were registered.

Example
If a car was first registered on 31 May 1978, it won’t need an MOT from 31 May 2018.

What drivers need to do
Drivers don’t have to apply to stop getting an MOT for their vehicle.

However, each time they tax their historic vehicle (even if they don’t pay a fee), drivers will have to declare it meets the rules for not needing an MOT.

Drivers must still keep their vehicle in a roadworthy condition. They can be fined up to £2,500 and get 3 penalty points for using a vehicle in a dangerous condition.

Why the changes were made
The changes were introduced as part of EU Directive 2014/45, which came into effect on 20 May 2018.

The UK voted to leave the EU in the 23 June 2016 EU referendum. The government is now preparing to leave the EU in the best possible way for the UK’s national interest.

However, the UK was still an EU member on 20 May 2018 when the directive came into force. The UK government could have faced ongoing substantial fines if it didn’t introduce the changes.

There’s also a risk that vehicles without a compliant EU MOT would not be allowed into other EU countries.

Video transcript:

So from the 20 May this year, the MOT test is changing in several ways.

So there’ll be some changes to the content of the MOT, although the basic essence the MOT is staying the same, there will be some changes to content.

There’ll also be changes to the defect categories, that vehicles pass and fail for, and the documentation that we issue at the end of an MOT will be changing to reflect that.

So there’s now going to be three defect categories; dangerous, major and minor. So for dangerous and major defects the vehicle will fail, for minor defects the vehicle won’t fail and of course, you’ll still be able to issue advisories for those components that aren’t yet defective but are wearing or on their way out.

So all of the new defects are described there in the MOT inspection manual and also in the MOT testing service. So as a tester you need to pick the defect that matches the defect on the vehicle and that will be set out as to whether it is either dangerous, major or minor.

The MOT documentation will be changing to reflect the new defect categories and also try and explain things much more clearly to motorists about what they need to do in their vehicle.

So if a vehicle fails the defects will be categorised on the failure documentation as dangerous, major or minor. If a vehicle passes any minor defects will also be shown on the pass certificate, together with any advisories.

You’ll be able to find out more detail about the changes to the MOT on GOV.UK. ↩